Auriol Z30398 User Manual download pdf (Page 15)

15 GB/IE

Before Initial Use / Putting the weather station into operation

Mounting the outdoor sensor on the wall:

Note: You will need an electric drill for this step of the installation.

m CAUTION! DANGER TO LIFE, RISK OF INJURY AND MATERIAL DAMAGE!

Read the operating and safety instructions for your drill carefully.

WARNING!

DANGER TO LIFE! Take care that you do not hit electricity, gas or

water lines when you drill into the wall. If necessary, check with a pipe and cable detector

before drilling.

Putting the weather station into operation

Inserting the battery:

j Open the battery compartment

on the back of the weather station.

j Insert two 1.5 V

batteries (AA) (supplied) in the battery compartment

Note: Ensure the correct polarity. This is shown in the battery compartment

j Close the cover of the battery compartment.

j Remove the protective ﬁlm from the LC display of the weather station.

Once the batteries are inserted, the weather station starts to receive the outdoor sensor signal.

This process does not take more than 3 minutes. During this time the reception symbol of

the outdoor sensor

ﬂashes. After successful reception of the outdoor sensor signal the

weather station starts to receive the DCF radio signal. This process may take up to 5 minutes

and is shown in the LC display by the ﬂashing

symbol

Reception may be seriously restricted by certain obstacles (e.g. concrete walls) or sources

of interference (e.g. other electrical devices). If interference with reception of the radio signal

continues, you can also set the time and date manually (see “Setting the time / date manually”).

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 93 94

No comments

Auriol Z30398 User Manual Page 15